PrimedDesign A Cast Iron CAD practice
Book an Edge Sprint
Primed.Design · A Cast Iron CAD practiceWhite-label margin

October 2026 · Dave Lock · 4 min read · Category: Manufacturing

Tooling amortisation: why white-label FBA margins keep falling

When several sellers buy the same product from the same factory, the cost of its tooling is spread across all of them, and every new seller it takes on makes the unit cheaper for the factory to supply to the next one. Your costs stay where they were, the price on the listing comes down to meet the newer sellers, and your margin is what takes up the difference.

Where does the margin go?

Into the price floor. Somewhere in the unit price you pay is the factory recovering what it spent on the mould, and while you were one of two sellers on that tool the share per unit was noticeable. With five or six sellers on it the share has shrunk for everyone, which sounds like good news until you look at the listings, because the saving tends to turn up as lower prices from the sellers who came in later rather than as extra margin for you.

Amazon ending commingling in March did not change any of this, as the note on the commingling change sets out, because the pressure comes from the product being the same, not from how the stock is pooled.

Will negotiating the factory down fix it?

Probably not for long. The factory’s position improved while yours got worse, so a discount is a one-off concession against a trend that carries on, and the next seller it signs up may well be offered the price you negotiated.

What about PPC, a listing refresh or a new supplier?

They help for a while, but none of them changes who owns the tooling. More PPC spends more to hold on to a margin that is shrinking, a refreshed listing can be copied within weeks, and moving supplier usually means another factory’s shared tooling and the same pattern starting again.

What changes the maths?

Owning the product, so the tooling is paid off against your units alone. That costs real money, a Design Phase from £6,000 + VAT plus the tooling itself, and it is not the right call for every seller or every category, which is why the first step should be a diagnostic that is allowed to say “don’t proceed” rather than a design proposal. What engineered product design costs sets out each stage.

How do you tell whether it is worth it for you?

Break your own numbers down: landed cost, the FBA fee stack, ad spend per unit, and where your selling price has gone over the last 12 months. If the margin you have lost per unit, multiplied by your volume, is bigger than the cost of owning the product over a payback period you can accept, the engineering is likely to pay for itself. If it is not, the better move is probably to hold, and the situations where we would say that are in when not to engineer a custom product.

How fast does it happen?

About as fast as new sellers arrive. Count the same-design listings that have appeared in your category over the last two quarters, because that number usually moves before your P&L shows it.

Edge Sprint

The Edge Sprint runs this breakdown on your own products and ends with a written recommendation.

We take three Sprint clients a quarter; we confirm your start date when you book. £1,250 + VAT, invoiced with your start date, paid before work starts.